Lenovo IdeaPad V460 - Manual (Page 34)

30
Appendix A. CRU instructions
Replacing the battery - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
„
To replace the battery, do the following:
1 Turn off the computer, or enter hibernation mode. Disconnect the AC
adapter and all cables from the computer.
2 Close the computer display, and turn the computer over.
3 Unlock the battery latches in the unlocked position , remove the
battery pack in the direction shown by the arrow .
4 Install a fully charged battery.
5 Slide the manual battery latch to the locked position.
6 Turn the computer over again. Connect the AC adapter and the cables to
the computer again.
Note: Use only the battery provided by Lenovo. Any other battery could ignite or explode.
Note: If you are using an ExpressCard device, the computer might not be able to enter
hibernation mode. If this happens, turn off the computer.
a
b
a
a
b
V460 User Guide V1.0_en.book Page 30 Wednesday, March 24, 2010 4:59 PM