Pump & drive shaft installation – Alamo JD-5225 User Manual

Page 29

Advertising
background image

© 2005 Alamo Group Inc.

Section 3 - 9

Switch Blade (JD-5105-5205-5225-5325-5425-5525, Asy. Man) 05/05

tighten all the cover retaining bolts. Caution must
be used to make certain that any hoses or wiring of
tractor are routed correctly and will not be dam-
aged because they have been moved around or
kinked.

14.

Re-install Battery. The battery can be rein-

stalled now along with the battery hold down. DO
NOT reconnect the batter cables to the batter at
this time.

15.

Re-install Engine Side Shields. Re-install

LH and RH side engine shields that were removed.
Use the same mounting hardware that was re-
moved (See Figure 21).

Figure 17

Figure 18

Bolster Plate

modification Cut

Out Seen From

Top

Bolster Plate

modification Cut

Out Seen From

Bottom

Axle

Pivot Pin

JD-5425 & JD-5525

Shown

Pump & Drive Shaft Installation:

Figure 14

Crankshaft

Alignment

Dimple

Figure 15

Figure 16

Cut

Hole

13.

Check Modified Bolster Cover for fit. Make certain the cover will not hit the crankshaft pulley,

pulley adapter or the splined hub (See Figure 17 & 18). If cover will not hit install the retaining bolts into
the cover that were removed when cover was taken off. Leave bolts loose until all bolts have been
in stalled this will allow the cover to be moved around for alignment. Once all the bolts are installed

Advertising
This manual is related to the following products: