ATEN CS-1708 - Manual (Page 14)

CS-1708 / CS-1716 User Manual
6
No. Component Description
1 Port LEDs The Port LEDs provide status information about their
corresponding KVM ports. There is one pair for each port.
The one on the left is the On Line LED; the one on the right
is the Selected Port LED:
Š
An On Line LED lights ORANGE to indicate that the
computer attached to its corresponding port is up and
running.
Š
A Selected LED lights GREEN to indicate that the
computer attached to its corresponding port is the one
that has the KVM focus. The LED is steady under
normal conditions, but flashes when its port is accessed
under Auto Scan Mode (see page 29).
Š
When the switch is first powered on, the On Line and
Selected LEDs blink in sequence as the Switch
performs a self-test.
2 Reset Switch Pressing this switch in performs a system reset. The
switch is recessed and must be pushed with a thin object -
such as the end of a paper clip, or a ball point pen.
3 Power LED The Power LED lights to indicate that the CS-1708 is
powered up and ready to operate.
4 Station ID LED The switch's Station ID is displayed here. If this is a Single
Station installation (see page 10), or the First Station on a
Daisy Chained installation (see page 12), the CS-1708 has
a Station ID of 01.
On a Daisy Chained installation, the CS-1708 auto-senses
its position and displays the Station ID that corresponds to
its place in the chain. (see Port ID Numbering, page 16, for
details).
cs1708-1716.book Page 6 Thursday, July 19, 2007 3:06 PM