Asus Leonite P5LP-LE - Manual (Page 9)

A S U S P 5 L P - L E ( L e o n i t e ) A S U S P 5 L P - L E ( L e o n i t e ) A S U S P 5 L P - L E ( L e o n i t e ) A S U S P 5 L P - L E ( L e o n i t e ) A S U S P 5 L P - L E ( L e o n i t e ) 5 5 5 5 5
3. System memory
The motherboard comes with four Double Data Rate 2 (DDR2) Dual Inline
Memory Module (DIMM) sockets.
A DDR2 module has the same physical dimensions as a DDR DIMM but has a
240-pin footprint compared to the 184-pin DDR DIMM. DDR2 DIMMs are
notched differently to prevent installation on a DDR DIMM socket.
The following figure illustrates the location of the DDR2 DIMM sockets.
3 . 1 3 . 1 3 . 1 3 . 1 3 . 1 Memory configurations Memory configurations Memory configurations Memory configurations Memory configurations
You can install 256 MB, 512 MB, and 1 GB DDR2 SDRAM DIMMs into the
DIMM sockets using the memory configurations in this section.
• Installing DDR2 DIMMs other than the recommended configurations
may cause memory sizing error or system boot failure. Use any of
the recommended configurations on the next page.
• Install only i d e n t i c a l i d e n t i c a l i d e n t i c a l i d e n t i c a l i d e n t i c a l (the same type and size) DDR2 DIMM pairs
using the recommended configurations.
• Make sure that the memory frequency matches the CPU FSB (Front
Side Bus). Refer to the Memory frequency/CPU FSB synchronization
table on the next page.
• This motherboard does not support double-sided 16-bit DDR DIMMs.
• Do not create a three-DIMM configuration in dual-channel mode. The
third DIMM is ignored in the dual-channel operation.
P5LP-LE
P5LP-LE (Leonite) 240-pin DDR2 DIMM sockets
XMM1 XMM2 XMM3 XMM4