Konica Minolta bizhub 751 - Manual (Page 15)

How to Use the Authentication Unit 5
AU-211P 77
5.4.2 Scan to SMB Related Settings
This section explains how to configure the Scan to SMB settings on the MFP.
Client Settings
Configure the setting to perform SMB TX.
On the MFP control panel, press the [Utility/Counter] key, and then
[Administrator Settings] - [Network Settings] - [SMB Settings] - [Client
Settings].
2
Note
Specify the WINS server or direct hosting service to fit your environment.
For details, refer to the User's Guide [Network Administrator] supplied
together with the MFP.
Item Description
ON/OFF Select [ON].
SMB Auth Setting Select [Kerberos] or [Kerberos/NTLMv2/v1] as the SMB
TX authentication method.
The default is [Kerberos]. In an NTLM authentication
environment, select [Kerberos/NTLMv2/v1].
DFS Setting To perform SMB TX in a DFS (Distributed File System)
environment, select "Enable".
Password Authentication
Restriction This system applies the user account of the CAC/PIV
card to perform authentication even if the user ID or
password is registered in the SMB TX address included
in the address book. In this item, specify the action to
be taken when authentication has failed using the user
account of the CAC/PIV card.
If "Limit" is selected, it results in an authentication
failure.
If "Do Not Limit" is selected, enter the user ID and
password on the control panel when sending data.