Konica Minolta bizhub 421 - Manual (Page 11)

Fax Driver 1-5
Overview 1
1.3 Setting up the system
In order to use this printing system, it must first be set up.
Setup consists of connecting this machine to a computer and installing the fax driver onto the computer
being used.
!
Detail
This manual describes the setup method of network connection only for Port9100/IPP/IPPS that will be
installed by the installer, and LPR/Port9100 that will be installed by Add Printer Wizard printing.
For installation procedures via other network connections, refer to the User’s Guide [Print Operations
(IC-207)].
It is possible to use the point and print install. However, please note that the server does not support
any OS other than the Windows NT when the client employs the Windows NT.
1.3.1 Network connection
1
Connect this machine to a computer.
2
Make sure the computer is connected to the network.
3
Specify the IP address of the machine to connect it to the network.
4
Depending on the connection method and protocol, change the network settings of this machine.
– LPR: Enable LPD print on the LPD Setting screen.
– Port9100: Enable the RAW port number (9100 at default), on the TCP/IP setting screen.
– SMB: Specify "Print Setting" on the SMB Setting screen.
– IPP/IPPS: Enable IPP print on the IPP Setting screen.
5
Install the fax driver.
– Specify the network port of the fax driver according to the connection method and protocol.
1.3.2 Local connection
2
Note
When a connection is made with the USB port, the local interface kit is required.
1
Connect this machine to a computer
2
Install the fax driver.
!
Detail
For details on connecting this machine to a computer, refer to the"User’s Guide [Print Operations (IC-
207)]".
To update an existing fax driver, delete the existing fax driver first. For details, refer to "Uninstalling the
fax driver" on page 2-19 .