Konica Minolta bizhub 421 - Manual (Page 60)

Fax Driver 4-3
Troubleshooting 4
4.2 Unable to specify desired settings or unable to send as specified
Perform these troubleshooting procedures if settings cannot be specified in the fax driver or if the fax is not
sent as specified.
2
Note
Some of the fax driver functions cannot be combined with other functions.
4.2.1 Error message
Symptom Probable cause Action
A fax driver setting cannot
be selected. Some functions cannot be combined. Do not try to select settings that are not
available.
The "Conflicts" message
with "Unable to Select" or
"Function Canceled" ap-
pears. An incorrect combination of functions has
been specified. Check the settings and specify the func-
tions correctly.
The fax is not sent as spec-
ified. Incorrect settings are specified. Check each setting in the fax driver.
A combination of functions, although
possible in the fax driver, is not possible
with this machine.
The paper size, orientation, and other set-
tings specified in the application have pri-
ority over those specified in the fax driver. Enter the correct settings in the applica-
tion.
The watermark cannot be
attached. The watermark is not correctly set. Check the watermark settings.
The watermark density is set to a level
that is too low. Check the density settings.
Watermarks cannot be outputed in
graphics applications. No watermark can be outputed in this
case.
Message Cause and remedy
Cannot connect to the net-
work. A connection to the network could not be established.
Check if the network cable is correctly connected. In addition, check that the Net-
work Setting parameters on the Administrator Setting screen have been correctly
specified.