Konica Minolta bizhub PRESS C1070 - Manual (Page 16)

bizhub PRESS C1070/C1070P/C1060 2-7
2.2 Installation Procedures 2
4
Insert the auxiliary guides (2 pieces) into the positioning screws
on the side guides.
NOTICE
Do not move the paper control levers (2 pieces). Otherwise, the
paper feeding performance may degrade.
5
Push in tray 5 until it locks into place.
Using Envelopes of 139.7 to 245 mm in Width
Follow the procedure below to use envelopes of the above size. Auxiliary guides (2 pieces) are not needed.
1
Pull out tray 5.
2
Move each of the small size guides (front/rear) toward the out-
side the side guide plates.
% If the auxiliary guides are installed on the side guides, pull
them up to remove them. The positioning screws (4 pieces)
installed on the side guides are not required to be removed.
3
Push in tray 5 until it locks into place.