Konica Minolta bizhub PRESS C1070 - Manual (Page 21)

bizhub PRESS C1070/C1070P/C1060 3-5
3.1 Removal Procedures 3
14
Store the removed fusing unit in the empty packaging of
EF-103.
NOTICE
Please wait until EF-103 gets cold before storing it in the
packaging.
3.1.2 Removing Parts from the Tray
If the auxiliary guides (2 pieces) are installed on the side guides of tray 5, perform the following steps to re-
move them.
NOTICE
Trays cannot be withdrawn when the machine is not powered. Plug the power cord of the machine into the
outlet, turn on the main power switch, then the sub power switch before removing parts from the tray.
1
Pull out tray 5.
2
Pull the auxiliary guides (2 pieces) up to remove them.
3
Close the small size guides (front/rear) to the direction of arrow
to place the guides back into the positions illustrated below.