Konica Minolta BIZHUB C652DS - Manual (Page 165)

bizhub C652/C652DS/C552/C552DS/C452 7-17
7.1 System Settings 7
Punch Regist Loop Size Adjustment
Correct the orientation of the paper and adjust the punched hole position to be parallel with the left edge of
the paper. The punched hole array is corrected by adjusting the resistance applied to the paper for each
paper type.
0 This adjustment is available if the punch kit is installed.
1
Press the [Utility/Counter] key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment]
ö [Finisher Adjustment] ö [Punch Regist Loop Size Adjustment].
First select the option to adjust the inclination of punch holes when the Finisher FS-526 and Post
Inserter PI-505 or Z Folding Unit ZU-606 are installed.
2
Select a paper type for which the punch hole angle is adjusted.
3
Press [+] or [-] to adjust the punched hole position.
4
Press [OK].
5
Create a sample, and check the print result.
Punch Edge Sensor Adjustment
If the punch position is displaced depending on the paper tray, the punch kit is automatically adjusted.
0 This adjustment is available if the Finisher FS-526 and the Punch Kit PK-516 are installed.
1
Press the [Utility/Counter] key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment]
ö [Finisher Adjustment] ö [Punch Edge Sensor Adjustment].
2
Press the [Start] key.
The punch edge sensor is automatically adjusted.
The adjusted result appears.
Vertical Punch (Z-Fold) Position Adjustment
Adjust the vertical position of the punched holes for each paper size.
0 Before making any adjustments, create a sample using the punch settings. Adjust the center staple
position while checking the created sample.
0 This adjustment is available if the Z Folding Unit is installed.
1
Select [Utility/Counter] ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment] ö
[Finisher Adjustment] ö [Vertical Punch (Z-Fold) Position Adjustment].
2
Select the size of paper of which the vertical punched hole position is adjusted.
3
Press [+] or [-] to adjust the punched hole position while checking the sample.
4
Press [OK].
5
Create a sample, and check the print result.