Konica Minolta bizhub 25 - Manual (Page 117)

2-64 Specifying the Network Settings
Press [Close].
34
Press [Attribute Setting].
35
Select the attribute to set, and enter the attribute.
36
Press [Close].
37
Press [Enter].
38
The message “This server has been set as a default server.” is displayed when you register the
first server.
Setting the Primary LDAP Server „
You can set the LDAP server to use for LDAP searching from the registered LDAP
servers.
Make sure to register at least one LDAP server in advance.
Press <Setting>.
1
Press [Management].
2
If an administrator password is set, enter the password and press [Enter].
3
If an administrator password is not set, proceed to step 4.
Press [Network Settings].
4
Press [LDAP Server Setting].
5