Konica Minolta bizhub 25 - Manual (Page 149)

4-2 Error Messages
Error Messages
When a transmission error occurs, or there is a problem with the machine, the
information lamp will illuminate, and an error message will be displayed or printed.
The information lamp will sometimes clear when <Stop> is pressed, and sometimes it will
not. When it does not clear, the error or problem in the machine must be resolved. The
information lamp will clear when the error is resolved.
Errors that will clear by pressing <Stop>:
Communication errors •
When the memory becomes full while receiving a fax or e-mail •
When the memory becomes full while storing a document •
Errors that will not clear by pressing <Stop>:
When the paper runs out or when a paper jam or document jam occurs •
When the toner runs out •
When a cover or cassette is open •
When a fatal error occurs in the machine •
Communication Errors
When a communication error occurs, the alarm sounds, and the information lamp
illuminates red. An error code and message indicating the cause and countermeasure
for the error is printed. A message is not printed when an error occurs while receiving
an internet fax, but the history screen of Message Board and journal report indicate the
error code and the countermeasure for the error.
Fax Communication Errors „
Error code Error message Countermeasure
D.0.1 Sending stopped. Please try again. Transmit the document again.
D.0.2 The line was busy. Please try again.
D.0.3 Fax job was cancelled by user.
D.0.7 Check condition of remote fax. Check the fax reception method used by the
receiving party.
D.0.8 No dial tone detection. Check line
connection. Check whether the modular cable is connected
correctly.
Check the dial tone detection settings in the user
install mode.
Check the location where the pause is entered,
and transmit the document again. These
symbols may not be required, depending on the
switchboard.
T.1.1 Confirm the remote fax. Check the correct fax number and transmit the
document again.
T.1.4 Fax job was cancelled by user. Transmit the document again.
T.2.1 Confirm the remote fax. Check the settings on the other machine.