Konica Minolta Magicolor 5440 DL - Manual (Page 3)

Introduction 1
Introduction
Thank you for contacting a technical support representative to obtain
information about returning your magicolor 5440 DL/magicolor 5450 for
warranty exchange. Follow these instructions very carefully.
If you need additional assistance, refer to the General Information Guide
(included with the original printer) or printer.konicaminolta.com for worldwide
sources of service and support.
Attention
Failure to follow these instructions could result in voiding your
warranty.
Exchange Procedure
Each of these steps is explained in detail in this guide.
1
Unpack and set up the exchange printer. See page 2.
2
Prepare the original printer—turn it off, remove the
power cord, interface cables, output tray, manual feed
tray, and waste toner bottle. See page 6.
3
Move the consumables (the four toner cartridges and
the transfer belt unit) from the original printer to the
exchange printer. See page 9.
4
Move any installed options (duplex option and/or lower
feeder unit) from the original printer to the exchange
printer. See page 16.
5
Plug in the exchange printer, attach the interface cables,
and turn it on. See page 17.
6
Repack the original printer, and call the shipper for
pickup. See page 20.