Konica Minolta MS7000 MKII - Manual (Page 46)

3 Scanner
3-13
The Scanner is connected to the PC and ready for
scanning by pressing the Start Key.
This display is blinking when the Scanner is in
operation.
The Scanner is not connected to the PC. Turn ON
the PC or connect the Scanner to the PC with the
interface cable.
The Lens is not mounted or is loose.
Check the Lens for correct installation and
reinstall it as necessary.
The Projection Lamp is burned out.
Replace the lamp.
* If the lamp goes out during a print cycle, a blank
print may be output.
The battery for Date Print has run down.
Turn OFF the Date Print function, or call your
Tech. Rep. for replacement of the battery.
Magnification warning display
Did the modification of the magnification by an
electronic zoom.
Lights up when setting besides the standard
magnification.
Display Code Description