Konica Minolta MS7000 MKII - Manual (Page 7)

• Always use this product in a well ventilated location. Operating the
product in a poorly ventilated room for an extended period of time
could injure your health. Ventilate the room at regular intervals.
• Whenever moving this product, be sure to disconnect the power
cord and other cables. Failure to do this could damage the cord or
cable, resulting in a fire, electrical shock, or breakdown.
• When moving this product, always hold it by the locations speci-
fied in the operator’s manual or other documents. If the unit falls it
may cause severe personal injury. The product may also be dam-
aged or malfunction.
• Remove the power plug from the outlet more than one time a year
and clean the area between the plug terminals. Dust that accumu-
lates between the plug terminals may cause a fire.
• When unplugging the power cord, be sure to hold onto the plug.
Pulling on the power cord could damage the cord, resulting in a
fire or electrical shock.
SAFETY INFORMATION
P-5
Precautions for Routine
• Do not store toner units, PC drum units, and other supplies and
consumables in a place subject to direct sunlight and high temper-
ature and humidity, as poor image quality and malfunction could
result.
• Do not attempt to replace the toner unit and PC drum unit in a
place exposed to direct sunlight. If the PC drum is exposed to
intense light, poor image quality could result.
• Do not unpack a toner unit or PC drum unit until the very time of
use. Do not leave an unpacked unit standing. Install it immediately
or poor image quality could result.
• Do not keep toner units and PC drum units in an upright position
or upside down, as poor image quality could result.
• Do not throw or drop a toner unit or PC drum unit as poor image
quality could result.
• Do not use this product in an area where ammonia or other gases
or chemicals are present. Failure to do so may shorten the service
life of the product, cause damage or decrease performance.
• Do not use this product in an environment with a temperature out-
side the range specified in the operator’s manual, as a breakdown
or malfunction could result.
• Do not attempt to feed stapled paper, carbon paper or aluminum
foil through this product, as a malfunction or fire could result.