Check dest. & send, Select line, 2 e-mail settings (e-mail/i-fax) – Konica Minolta BIZHUB C360 User Manual
Page 110: E-mail settings, Document name, Check dest. & send -59 select line -59, Nd] (p. 5-59, P. 5-59)
bizhub C360/C280/C220
5-59
5.12
Communication Settings
5
Check Dest. & Send
The specified fax number is compared with the remote fax number (CSI) and data is sent only when those
fax numbers match. If they do not match, the communication will fail; therefore preventing a sending error.
Reference
-
To check the destination and send, the fax number of this machine must be registered with the recipi-
ent's fax machine.
Select Line
If 2 units of the Fax Kit FK-502 are installed, you can select [Line 1] or [Line 2] to send a fax. Specify the line
used for sending faxes. Selecting [Not Set] uses an idle one of lines 1 and 2 to send data. If both lines are
idle, Line 1 is used first.
Reference
-
You cannot specify a line when [Line 2 Setting] is set to [RX Only] in [Multi Line Settings].
-
To use two lines as external and extension lines, be sure to specify the line to be used. If you select [Not
Set], a sending failure may occur.
5.12.2
E-Mail Settings (E-mail/I-FAX)
E-mail Settings
Specify the Document Name, Subject, From and Body for sending E-mail messages.
[Document Name]
The name of the file to be saved is displayed. This document name can also be specified in [Document Name]
of [Scan Settings]. The document name whichever is specified later will be applied to this column. You can
enter up to 30 characters.