Konica Minolta Di650 - Manual (Page 4)

4
Tandem Mode Operation (continued)
FOR DETAILS
The Sub icon will display on the Basic Screen of the secondary copier
when [
Start ] is pressed on the primary copier to start the tandem
printing operation.
FOR DETAILS
The tandem mode cannot be selected/continued in the cases shown
below. The message “Please wait/ Reserve is not available in Sub
machine,” “Sub machine error/ Please check sub machine,” or “Please
check sub machine” will be displayed, as required.
• The tandem mode cannot be selected while the secondary copier is
in the off state, due to Auto shut-off. Press [ Energy Saver ] to release
it.
• Selected tandem mode will be released automatically when the
secondary copier activates Auto shut-off. Press [ Energy Saver ]] to
release it, then select the tandem mode again to restart the
procedure.
• When any problem occurs in the secondary copier, such as a paper
misfeed or lack of paper, the secondary copier will be unavailable for
printing; however, the problem will not cause tandem mode to be
released. Take the appropriate troubleshooting measures to be ready
for copying.
• Tandem printing job cannot be started if 5 reserve jobs (not in tandem
mode) are entered on the secondary copier. Wait until the reserve
jobs are completed on the secondary copier.
• Selected tandem mode will be released automatically when the
primary copier activates Auto low power/Auto shut-off.
Press [
Energy Saver ]] to release Auto shut-off if required, then select
the tandem mode again to restart the procedure.
4.
Select the desired copying conditions on the primary copier.
FOR DETAILS
Ordinary copying operation is still available on the secondary copier
during the tandem mode setting.
5.
Enter print quantity on the primary copier, using the keypad.
When a print quantity amount of 100 is entered, the primary and secondary
copiers will each copy and output 50 sheets.
FOR DETAILS
• Print quantity must be set for [2] or more copies to activate the
tandem mode.
• When the print quantity entered is an odd number, the primary copier
will copy and output one sheet/set more than the secondary copier to
accommodate the job.