Konica Minolta bizhub 751 - Manual (Page 197)

751/601 4-30
Application Software 4
6
Type the 8-digit Administrator Password registered in the machine in the "Administrator Password"
box.
7
Click the [Next].
? What happens if a wrong Administrator Password is entered?
% If a wrong Administrator Password is entered, a message appears saying that there is a mismatch
in the passwords. Enter the correct Administrator Password.
% If the Enhanced Security mode is set to [ON], entry of a wrong password is counted as unauthorized
access. If a wrong Administrator Password is entered a predetermined number of times (once to
three times) set by the Administrator of the machine or more, a message appears saying that the
machine accepts no more Administrator Passwords because of unauthorized access for any
subsequent entry of the Administrator Password. The machine is then set into an access lock state.
To cancel the access lock state, settings must be made by the Service Engineer; or, turn off, and
then turn on, the main power switch of the machine. If the main power switch is turned off and on,
the access lock state is canceled after the lapse of time set for [Release Time Settings]. When the
main power switch is turned off, then on again, wait at least 10 seconds to turn it on after turning it
off. If there is no wait period between turning the main power switch off, then on again, the machine
may not function properly.
Here is the sequence, through which the main power switch and sub power switch are turned on
and off:
Turn off the sub power switch
→ Turn off the main power switch → Turn on the main power switch →
Turn on the sub power switch
8
Check the data that has been set and click [Start].