Konica Minolta Printgroove - Manual (Page 60)

Operations for Placing an Order 4
Printgroove POD Serve 4-8
– To add another file, click the [Add New] button. On the screen that
opens, navigate to the file you wish to add. Select the file then click
the [Open] button. The file opens in its native application. Repeat
Steps 1 through 6 on the new file. When PRN conversion is com-
plete, the file is added to [Available Drivers]. Repeat this procedure
to add all required files.
– All files in the list will be combined sequentially into a single PDF file,
the first file will be at the beginning of the PDF file, the last file, at
the end. To change the position of a file in the list, click on the file
then use the [Up] and [Down] buttons to modify the file’s position.
– To remove a file from the list, select the file and click the [Delete]
button.
– To remove all files from the list, click the [Delete All] button.
– Note: If you Delete files, a pop-up screen will verify your request.
8
When [Available Drivers] contains all files you want to transfer, in the or-
der in which you want them combined, click the [Next] button. The
[Driver Selection] screen opens:
– All supported Printgroove POD modules appear in [Available Driv-
ers] drop-down menu.
9
Select [Printgroove POD Serve] from the [Available Drivers] drop-down.
10
Click the [Options>>] button on the [Driver Selection] screen. The
screen expands to include all Options and Module Configuration set-
tings: