Resetting the printer to factory defaults, Resetting the printer to factory defaults 34 – Konica Minolta PagePro 1350EN User Manual
Page 41
Resetting the printer to factory defaults
34
Resetting the printer to factory defaults
If the printer was manually configured to an invalid IP address, or moved to a
different network, and communication cannot be established anymore, you
might have to reset it to factory settings to re-enable DHCP/BOOTP auto-
matic protocols. In such a case, please follow these steps:
1
Turn on your printer.
When the green “Ready” indicator is on, reset the printer to factory
default.
2
Make sure that
–
the orange “Error” indicator is off.
–
the green “Ready” indicator is on (but not blinking).
3
Press the cancel button for more than 20 seconds, until:
–
the orange “Error” indicator and the green “Ready” indicator are slowly
blinking alternately (about 1 blink per second).
4
Press the cancel button one more time.
–
the green “Ready” indicator blinks for a few seconds, then stops blink-
ing and remains on.
5
Restart the printer to use the new (factory) settings.