Acer Aspire M5640 - Manual (Page 48)

42
The following table describes the parameters found in this menu.
Parameter Description Options
Init Display
First Initialize the AGP video display before initializing
any other display device on the system. Thus the
AGP display becomes the primary display.
Reset
Configuration
Data Normally, you leave this field Disabled. Select
Enabled to reset Extended System Configuration
Data (ESCD) when you exit Setup if you have
installed a new add-on and the system
reconfiguration has caused such a serious conflict
that the operating system cannot boot [Enabled],
[Disabled]
Resources
Controlled By This item allows user to assign PnP resource (I/O
address, IRQ&DMA channels) for Plug and Play
compatible devices automatically or manually [Auto]
[Manual]
IRQ Resources When resource are controlled by manually, assign
each system interrupt a type , depending on the type
of device using the interrupt.
Option:
[PCI Device]: Assign this IRQ for PCI device.
[Reserved]: Reserve this IRQ for other device.
[Press Enter]
PCI/VGA
Palette Snoop This option is only very rarely needed. It should be
left at “Disabled” unless a video device specifically
requires the setting enabled upon installation. [Disabled],
[Enabled]
Maximum
Payload Size This field displays maximum payload size of the
system [128-4096]
PCI 1/2 IRQ
Assignment This item allows user to assign PCI IRQ for device [Auto], [3] ,
[4] , [5] , [6] ,
[7], [10] ,
[11] , [12] ,
[14] , [15]