Xerox DocuColor 240-250 con Xerox FreeFlow DXP250-14674 - Manual (Page 22)

Using the lp utilities Using the lp Utilities for Solaris
Save
–o print|save
Save the specified job. Print is the default option and only
needs to be specified if the job is being submitted to a
save queue.
–o savedest=<destination>
Specify the save location of the job relative to the save
location set at the DocuSP controller. For example, if the
save location at the controller is /home/savefiles and the
save location for the job should be /home/savefiles/orilee,
then the command is:
lp -d ps1 -o save savedest=orilee test.ps
Sides printed
–o <simplex|duplex|tumble>
Specify simplex, duplex, or tumble duplex for the print job.
The default is "simplex".
Tumble duplex printing causes a 180-degree rotation of
alternating pages. Both sides of the page are printed but
the position of the image is reversed (from top to bottom)
on every other page.
NOTE: The use of tumble duplex is restricted by certain
characteristics of the PostScript master. If you have
difficulty using this option, contact your Xerox
representative for assistance.
Slip sheets
–o <slipsheet>
Specify a slip sheet to be placed between the sets of your
document. The slip sheet paper stock is set at the
DocuSP controller.
Start message
-o startmsg=<text>
Type a message, up to a maximum of 100 characters. For
example, you might type a message that specifies some
unique job programming that must be provided by the
printer operator. Be sure to advise the printer operator
that the job contains a message.
2-8