Problems using a unix environment, Problems using an smb environment – Xerox WorkCentre M118-M118i-15205 User Manual
Page 119
Problems using a UNIX Environment
Xerox CopyCentre/WorkCentre 118 System Administration Guide
119
When the document cannot be deleted from the printer window
Problems using a UNIX Environment
This section explains what to do when a problem occurs while using UNIX. The
possible causes, confirmation methods, and actions are as follows. If a problem still
exists after the corrective action has been performed, follow the Problem Solving
Procedures on page 111 to seek further assistance.
When printing fails – page 119
When the required printing result is not obtained – page 121
When printing fails
The number of sessions
exceeds the maximum.
Check that the machine is
processing simultaneous
requests (such as print
request or status inquiry
request) from multiple clients.
In Windows 95/Windows 98/
Windows NT 4.0, the write
error dialog, which indicates
insufficient memory for the
waiting print job is displayed.
Wait for a while, send a print
request again. Alternatively,
increase the [Maximum
Sessions] in the SMB setting
file [config.txt]. Then switch
the power off and on. (Only
the Key Operator)
Cause
Confirmation Method
Action
Cause
Confirmation Method
Action
An attempt is made to delete
all documents displayed in
the printer window. (Only the
Key Operator)
Check whether the attempt is
made to delete the print job
from the Printer menu in the
printer window.
Delete the print job from the
Document menu in the printer
window.
The document owner is
invalid.
Check whether the owner of
the selected document
matches the Windows log-in
name.
Use the owner name of the
document to log in to
Windows, then delete the
document.
Service Pack 4.0 or later is
not installed in the system.
(In Windows NT 4.0)
Check the Service Pack
version displayed to be
displayed when you start
Windows NT 4.0.
Install Service Pack 4.0 or
later.
Cause
Confirmation Method
Action
The IP address is not correct. Check whether the IP
address of the machine is
correct.
Specify the correct IP
address for the machine.