Xerox WorkCentre M118-M118i-15205 - Manual (Page 33)

Xerox CopyCentre/WorkCentre 118 System Administration Guide 33
3 NetWare
This chapter explains how to install the machine onto a NetWare network. The following
information is provided.
Information Checklist – page 33
NetWare Environments – page 34
NetWare Installation – page 35
Installation Procedure – page 35
Network Communication Setup – page 35
NetWare Setup – page 37
Workstation Setup – page 37
Test Print – page 37
Information Checklist
Before installing the machine onto a network, make sure that the following items are
available or have been performed.
If problems arise during the machine installation, refer to Problem Solving chapter for
assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Item By
An existing operational NetWare network is required. These procedures
are not designed to install a NetWare network. Customer
NetWare versions 3.x, 4.x, 5.x or 6.x. Customer
Obtain and record the following information, if required:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed. Customer
Test the machine to make sure that it is installed fully and functioning
correctly. Customer
Print driver for the machine Customer