Operating instructions – Audiovox ACD-25 User Manual
Page 6
5
5
5
5
5
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
OPERATING
INSTRUCTIONS
OPERATING
INSTRUCTIONS
OPERATING
INSTRUCTIONS
OPERATING
INSTRUCTIONS
OPERATING
INSTRUCTIONS
1
ON/OFF POWER BUTTON
Press this button to turn the unit on or off.
2
VOLUME / LEVEL CONTROL
To increase the volume level, press the “VOL
”
button. The volume will increase and the level will
be shown on the display panel from a minimum of
“VOL 00” to a maximum of “VOL 51”. To increase
the volume quickly, keep the button pressed. To de-
crease the volume level, press the “VOL
” button.
Keep the button pressed to decrease the volume
quickly. The display will automatically return to the
normal indication 5 seconds after the last volume ad-
justment or when another function is activated. These
buttons are also used in conjunction with the Select
button
3
to adjust the bass, treble, balance, and
fader levels as described in
4
,
5
,
6
and
7
.
3
SELECT BUTTON (SEL)
CONFIRMATION TONE SELECTOR (
)
This button is used to select the audio function (vol-
ume, treble, bass, balance, or fade) to be adjusted
using the Level Control
2
. Pressing the Select
button once will set the unit for treble adjustment
(“TRE” will appear on the display panel). Pressing
the button additional times will select bass (“BAS”
on the display), balance (“BAL”), fader (“FAD”) or
volume (“VOL”). The display will automatically re-
turn to the normal indication 5 seconds after the last
adjustment or when another function is activated.
Pressing and holding the button for longer than 2
seconds will activate the Confirming Tone feature as
indicated by two beep tones and the
indication
appearing on the display panel. When activated, the
unit will produce a single beep tone whenever a mo-
mentary press function is activated and two beep
tones whenever a press and hold function is acti-
vated (ie. Auto-Store Tuning, etc.). To deactivate this
feature, press the button again for longer than 2 sec-
onds ( the
indication will disappear from the
display panel).
4
TREBLE CONTROL
To adjust the treble level, first select the Treble mode
by pressing the Select button
3
so that the “TRE”
indication appears on the display panel. Within 5
seconds of choosing the Treble mode, press the
or
button of the Level Control
2
to adjust the
treble response as desired. The treble level will be
shown on the display panel from a minimum of
-7 to a maximum of +7 (0 is flat response). The display
will automatically return to the normal indication 5 sec-
onds after the last adjustment or when another function
is activated.
(
(
( )
)
)
(
(
( )
)
)
(
(
( )
)
)