Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 163)

Specifying input parameters
Using LCDS Print Description Language 2-55
The following sections describe the syntax of the VOLUME
command parameters and explain the parameter options.
VOLUME KANJI Specifies double-byte character printing mode
and allows printing of data streams of
intermixed single-byte and double-byte
characters. Y N N
VOLUME KCODE Specifies the double-byte character code
translation table that the system will use to
interpret the input data. Y N N
VOLUME LABEL Specifies the type of label on the input tape. N Y N
VOLUME LCODE Specifies the code translation table that will be
used in interpreting the tape label. N Y N
VOLUME LPACK Specifies whether undefined labels are
packed or unpacked. N Y N
VOLUME MAXLAB Specifies longest physical block that may be
treated as a label if the label is undefined. N Y N
VOLUME MINLAB Specifies the shortest physical block that may
be treated as a label if the label is undefined. N Y N
VOLUME OPTIMIZE Specifies throughput performance
enhancement. Y N N
VOLUME OSCHN Specifies the channel that the system sill use
to signal the end of a report. N Y N
VOLUME OSHDP Specifies the number of header banner pages
that precede the report. N Y N
VOLUME OSTLP Specifies the number of trailer banner pages
that follow the report. N Y N
VOLUME RMULT Specifies a multiplication factor used to
determine the true record length. N Y N
VOLUME TCODE Specifies a set of type assignments that will
be used for masked comparisons. Y Y N
VOLUME UNPACK Specifies unpacking method of the input data
when unpacking is required. N Y N
VOLUME VCODE Specifies a table of character type codes to
use for criteria testing in Value mode. Y Y N
Table 2-56. Summary of VOLUME command parameters (Continued)
Parameter Specifies Online Offline DJDE