Agri-Fab 130 LB Tow Spreader 45-0463 - Manual (Page 4)

4
aSSemBLY inSTrucTionS
Figure 2
Figure 1
Figure 3
SPACER
PRE-ASSEMBLED
1/4" NYLOCK NUT
5
25
56
56
16
TooLS required For aSSemBLY
(1) Hammer
(2) 7/16" Wrenches
(2) 1/2" Wrenches
Lay out and identify parts and hardware using the
illustrations on pages 2 and 3.
STep 1: (See Figure 1)
Remove pre-assembled 1/4" nylock nuts and spacers •
from inside of hopper tubes. Discard spacers once
removed. Set aside 1/4" nylock nuts for use in step 2.
STep 3: (See Figure 3)
Press a tube plug (25) into the hitch tube (5). •
Assemble the back holes in the hitch tube (5) to the •
hitch support tubes using two 1/4 x 2" hex bolts (56)
and 1/4" nylock nuts (16).
Tighten all nuts and bolts
assembled up to this point.
16
12
STep 2: (See Figure 2)
Attach the RH hitch support tube (2) and LH hitch •
support tube (3) to the inside of the hopper tubes using
pre-assembled bolts, two 1/4" x 1-1/2" hex bolts (12),
and four 1/4" nylock nuts (16).
do not tighten yet.