AEG SCT81800S1 - Manual (Page 5)

• The appliance must not be located
close to radiators or cookers.
• Make sure that the mains plug is ac-
cessible after the installation of the ap-
pliance.
• Connect to potable water supply only
(If a water connection is foreseen).
1.6 Service
• Any electrical work required to do the
servicing of the appliance should be
carried out by a qualified electrician or
competent person.
• This product must be serviced by an
authorized Service Centre, and only
genuine spare parts must be used.
1.7 Environment Protection
This appliance does not contain
gasses which could damage the
ozone layer, in either its refriger-
ant circuit or insulation materials.
The appliance shall not be dis-
carded together with the urban
refuse and rubbish. The insula-
tion foam contains flammable
gases: the appliance shall be dis-
posed according to the applica-
ble regulations to obtain from
your local authorities. Avoid
damaging the cooling unit, espe-
cially at the rear near the heat ex-
changer. The materials used on
this appliance marked by the
symbol
are recyclable.
2. CONTROL PANEL
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1
Fridge Pilot light
2
Fridge ON/OFF switch
3
Fridge temperature regulator, + but-
ton
4
Fridge temperature indicator
5
Fridge temperature regulator, - but-
ton
6
DYNAMICAIR indicator
7
DYNAMICAIR button
8
Appliance Pilot light
9
Appliance ON/OFF switch
10
Freezer temperature regulator, +
button
11
Freezer temperature indicator
12
Freezer temperature regulator, -
button
13
FROSTMATIC indicator
14
FROSTMATIC button
15
Alarm indicator
16
Alarm reset button
2.1 Switching on
1. Insert the plug into the mains sock-
et.
2. Press ON/OFF switch .
3. The Pilot Light will light up.
4. The alarm indicator light flashes
since the temperature is reached.
The acoustic alarm sounds.
5. Press the alarm reset button to reset
the alarm.
ENGLISH
5