AEG T65170AV - Manual (Page 23)

When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and air filter ajar, to
prevent mildew and odours.
5. Close the water tap.
10.14 Draining water out after
end of cycle
The washing programme is completed,
but there is water in the drum:
• The drum turns regularly to prevent
the creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, decrease the spin
speed.
2. Touch the Start/Pause button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator goes off,
you can open the door.
4. Press On/Off some seconds to
deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
10.15 AUTO Stand-by option
The AUTO Stand-by option automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you press Start/Pause
button.
Press the button On/Off to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the button On/Off to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.
11. DAILY USE - DRYING
WARNING!
Refer to Safety chapters.
11.1 Preparation to drying
WARNING!
Open the water tap. Put
the drain hose in the sink
or connect to the drain
pipe.
1. Press buttonOn/Off for some
seconds to activate the appliance
2. Load the laundry one item at a time.
3. Turn the programme dial to the
drying programme applicable for the
items to dry.
The text bar in the display tells which
programme you have chosen.
When drying a big amount
of laundry, to have good
drying performances, make
sure that the laundry itself is
not rolled up and that is
uniformly distributed in the
drum.
ENGLISH 23