AEG L75480WD - Manual (Page 16)

If you turn the programme dial to
another programme when the
appliance is working, the yellow
pilot light of button 8 blinks 3
times. The display shows the
message Err to indicate a wrong
selection. The machine will not
perform the new set programme.
9.4 Setting the SPIN speed
(button 2)
When you set the programme, the appli-
ance automatically proposes the maxi-
mum spin speed allowed by that pro-
gramme.
Press this button repeatedly to change
the spin speed. The relevant light will
light up.
RINSE HOLD : the water of the last rinse
is not emptied out to prevent the fabrics
from creasing. When the programme
has finished the display shows a blinking
.
The DOOR pilot light goes on.
The pilot light of button 8 is off. The
door is blocked to indicate that the wa-
ter must be emptied out.
To empty the water out please read
chapter «At the end of the pro-
gramme».
9.5 Setting the STAIN option
(button 3)
Set this option to treat heavily soiled or
stained laundry with stain remover
The appliance extends the main wash
phase and intensifies the stain action
phase. The relevant light illuminates.
This option is not available with
a temperature lower than 40°C.
If you wish to perform a programme with
the stain option, pour stain remover into
compartment
.
9.6 Setting the TIME SAVING
option (button 4)
This option allows you to modify the
washing time, automatically proposed
by the appliance.
Press button 4
once
DAILY The relative pilot light
comes on.
The washing duration will
be reduced to wash daily
soiled laundry.
Press button 4 twice
SUPER
QUICK The relative pilot light re-
mains lit.
The washing duration will
be reduced to wash lightly
soiled laundry or items
used or worn for a short
time.
The display shows the decreased wash-
ing time.
9.7 Setting the EXTRA RINSE
option (button 5)
This appliance is designed for saving wa-
ter.
However, for people with a very delicate
skin (allergic to detergents) it may be
necessary to rinse the laundry using an
extra quantity of water (extra rinse).
The appliance will perform some addi-
tional rinses.
9.8 Starting the programme
(button 8)
Press the button 8 to start the pro-
gramme. The corresponding red pilot
light stops blinking.
The pilot light A is on to indicate that
the appliance starts operating.
The pilot light C is on to indicate the
door is locked.
Press the button 8 to interrupt a pro-
gramme which is running. The corre-
sponding red pilot light starts blinking.
Press the button 8 again to restart the
programme from the point at which it
was interrupted
If you have chosen a delayed start with
button 9, the machine will begin the
countdown.
If you set an incorrect option, the yellow
pilot light of the button 8 blinks for 3
times. The display shows the message
Err for some seconds.
16 www.aeg.com