AEG DC7003000M - Manual (Page 10)

5. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
5.1 Initial Cleaning
Remove all accessories and removable
shelf supports from the appliance.
Refer to "Care and
cleaning" chapter.
Clean the appliance before first use.
Put the accessories and the removable
shelf supports back to their initial
position.
5.2 First Connection
When you connect the appliance to the
mains or after the power cut, you have to
set the language, the display contrast,
the display brightness and the time of
the day.
1. Use the shuttle to set the values.
2. Press
to confirm.
5.3 Calibration
For the best results with the function:
Auto Cooking, you must calibrate the
appliance. The calibration time is 4
hours.
If you use manual cooking
only, you can ignore this
procedure.
Conditions:
• The temperature in the kitchen must
be below 35 °C.
• Install the appliance in its permanent
location.
• Connect the appliance to the mains
supply and do not disconnect it again.
• If you change the appliance location
or electrical connection, you must do
the steps again.
Calibration:
1. Activate the appliance.
2. Select the menu: Basic Settings and
press OK.
3. Select the function: Calibration and
press OK.
When you calibrate for the
first time, to start the
procedure you can set the
category from the control
panel or select the function
from the main menu: Auto
Cooking.
CAUTION!
Make sure that the
appliance is cool before you
use it.
6. DAILY USE
WARNING!
Refer to Safety chapters.
6.1 Navigating the menus
1. Activate the appliance.
2. Use the shuttle clockwise or
counterclockwise to select the menu
option.
3. Press to move to the submenu or
accept the setting.
www.aeg.com 10