AEG Double Plug Socket DH 200 - Manual (Page 10)

19 18 GB
AssEMBlY AnD connEctIon
Model DB 130
Connecting to a 12-V vehicle socket:
1. Insert the vehicle plug [10] into the 12 v vehicle socket.
2. place the double plug socket in such a way that the unit or the cable does
not hinder the driver.
Model DH 200
Connecting to the vehicle battery:
the DH 200 model is connected directly to the battery with the ring terminal
connector cable.
Warning! the connecting cable from the double plug socket must run through
the interior of the vehicle. this is usually achieved by running it along a section
of vehicle body panelling.
If you are unable to run the cable through the interior of the vehicle yourself,
take the job to a vehicle repair shop.
▪
If the connecting cable has to be led through sharp or rough walls (e.g.,
metal panels), use rubber grommets or cable channels to avoid damage to
the cable.
▪
lay and fasten the cable in such a way that it cannot come into contact with
any movable, hot or sharp-edged parts.
1. place the double plug socket in such a way that you are not hindered by
the unit or the cable whilst driving.
2. lead the double plug socket connecting cable from the vehicle interior to the
battery.
3. connect the terminal connection cable (red ring connection) (+) [6] to the
positive terminal on the battery.
4. connect the terminal connection cable (black ring connection) (-) [5] to the
negative terminal on the battery.
5. connect the comfort connection plugs [8] with one another.
opERAtIon
Model DB 130
As soon as the vehicle plug [10] is connected with the 12 v vehicle socket and
is conducting an electrical charge, the red lED will illuminate. now the double
plug socket is ready for use and devices can be connected to both 12 v vehic-
le sockets, as well as to the UsB connection socket.
note that with some vehicles, the 12 v vehicle socket may only function when
the ignition is switched on.
Use the double plug socket for a short time only if the vehicle engine is not
switched on. Failure to ob-serve this can cause the vehicle battery to run down.
After use, always remove the plug from the 12 v vehicle socket. when remo-
ving the connection, pull on the plug itself, and never on the connecting cable.
Model DH 200
to switch the unit on, switch the on/oFF switch [4] on the double plug socket
to on. now the double plug socket is ready for use.
▪
Make sure that the total power consumption connected to the double plug
socket does not exceed 15 A.
voltage Indicator lED functions [3]:
Red current < 10.5 v
Yellow current between 10.5 v-12.5 v
Green current > 12.5 v
Battery monitor function: As soon as the double plug socket is switched on, an
lED illuminates which corresponds to the battery voltage. If the battery voltage
sinks below 10.5 v, the lED will light up red. If this happens, the double plug
socket will automatically switch off in order to prevent the vehicle battery from
running down. this will resume if the battery return to 11.8 v or above.