AEG HG694340NB - Manual (Page 14)

Problem Possible Remedy
The residual heat indica-
tor does not come on. The cooking zone is not
hot because it operated
only for a short time. If the cooking zone oper-
ated sufficiently long to
be hot, speak to the
service centre.
The Automatic Heat Up
function does not oper-
ate. The cooking zone is hot. Let the cooking zone be-
come sufficiently cool.
The highest heat setting
is set. The highest heat setting
has the same power as
the Automatic Heat Up
function.
The heat setting changes
between two levels. The Power management
is activated. Refer to “Power man-
agement”.
The sensor fields be-
come hot. The cookware is too
large or you put it too
near to the controls. Put large cookware on
the rear cooking zones if
necessary.
There is no signal when
you touch the panel sen-
sor fields. The signals are deactiva-
ted. Activate the signals. Re-
fer to “OffSound con-
trol”.
comes on The Automatic Switch
Off operates. Deactivate the appliance
and activate it again.
comes on The Child Safety Device
or the Lock function op-
erates. Refer to the chapter
“Daily Use”.
comes on There is no cookware on
the cooking zone. Put cookware on the
cooking zone.
The cookware is incor-
rect. Use the correct cook-
ware.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone. Use cookware with cor-
rect dimensions.
The cookware does not
cover the cross. Cover the cross / square
fully.
and number comes
on.
There is an error in the
appliance. Disconnect the appli-
ance from the electrical
supply for some time.
Disconnect the fuse from
the electrical system of
the house. Connect it
again. If
comes on
again, speak to the serv-
ice centre.
14 www.aeg.com