AEG T76485AH - Manual (Page 16)

• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g.
with a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus and Anti-crease
buttons.
One of the symbols goes into the view
on the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the Start/Pause button again
and again until you set necessary
degree.
6. To memorise the setting, push at the
same time the Dry Plus and Anti-
crease buttons for approximately 2
seconds.
10.3 Deactivating the Tank
indicator
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus and Buzzer
buttons.
One of 2 configurations is possible:
• the Tank indicator: is on and the
symbol goes into the
view - the water container
indicator is permanently on
• the Tank indicator: is off and the
symbol goes into the
view - the water container
indicator is permanently off
11. CARE AND CLEANING
11.1 Cleaning the filter
At the end of each cycle the indicator
Filter is on and you must clean the filter.
The filter collects the fluff.
The fluff occurs while the
clothes are dried in the
tumble dryer.
To clean the filter:
1. Open the door. Pull the filter.
2. Open the filter.
3. Use a moist hand to clean the filter.
www.aeg.com 16