AEG A71101TSX0 - Manual (Page 11)

CAUTION!
Unplug the appliance before car-
rying out any maintenance oper-
ation.
This appliance contains hydrocar-
bons in its cooling unit; mainte-
nance and recharging must
therefore only be carried out by
authorized technicians.
6.2 Periodic cleaning
The equipment has to be cleaned regu-
larly:
• clean the inside and accessories with
lukewarm water and some neutral
soap.
• regularly check the door seals and
wipe clean to ensure they are clean
and free from debris.
• rinse and dry thoroughly.
Do not pull, move or damage
any pipes and/or cables inside
the cabinet.
Never use detergents, abrasive
powders, highly perfumed clean-
ing products or wax polishes to
clean the interior as this will dam-
age the surface and leave a
strong odour.
Clean the condenser (black grill) and the
compressor at the back of the appliance
with a brush. This operation will improve
the performance of the appliance and
save electricity consumption.
Take care of not to damage the
cooling system.
Many proprietary kitchen surface clean-
ers contain chemicals that can attack/
damage the plastics used in this appli-
ance. For this reason it is recommended
that the outer casing of this appliance is
only cleaned with warm water with a little
washing-up liquid added.
6.3 Defrosting
Your appliance is frost free. This means
that there is no buildup of frost when it is
in operation, neither on the internal walls
nor on the foods.
The absence of frost is due to the con-
tinuous circulation of cold air inside the
compartment, driven by an automatically
controlled fan.
7. TROUBLESHOOTING
During operation of the appliance some
smaller but annoying trouble can often
occur, which does not require calling a
technician out. In the following chart in-
formation is given about them to avoid
unnecessary charges on service.
The operation of the appliance
goes with certain sounds (com-
pressor and circulating sound).
This not means a trouble, but a
normal operation.
The appliance operates discon-
tinuously, so the stopping of
compressor does not mean be-
ing no current. That is why you
must not touch the electrical
parts of the appliance before
breaking the circuit.
Problem Possible cause Solution
The appliance is
noisy. The appliance is not sup-
ported properly. Check if the appliance
stands stable (all feet and
wheels should be on the
floor). Refer to "Levelling".
ENGLISH
11