AEG Vehicle Multilight KL3 User Manual

Page 12

Advertising
background image

12

mains if liquid has been spilt. Do not use the Vehicle Multilight and request assistance
from specialist staff.

Fire risk! Remove the charging unit from the mains when the Vehicle Multilight is fully
charged or is not required for use.

Fire risk! Cease using the Vehicle Multilight immediately if smoke exudes from the
unit, or if it smells unusual.

Fire risk! The Vehicle Multilight may be charged only using the 230 V charging unit
provided, in connection with a 230 V / 50 hertz mains socket or with a 12 V vehicle
charging cable from a 12 V vehicle socket.

Injury and accident danger! If you transport the Vehicle Multilight within a vehicle,
keep it in the boot or in a suitable compartment so that it does not risk getting dama-
ged by sudden vehicle movement.

Injury danger! Do not look directly into the beam of light or shine the beam into the
eyes of other people. This can cause temporary blindness or damage the retina.

Injury danger! Do not attempt to change, open or manipulate the Vehicle Multilight
as this can increase the danger factor.

warning! The Vehicle Multilight is not waterproof and not for use in humid surroun-
dings.

Injury danger! Do not expose the charger to fire or to extreme heat. Doing this can
cause the charger to burst or explode.

Danger of acid burns! A damaged charger can leak corrosive vapour or liquid. If
this occurs, make sure that a fresh air supply is restored and wash the affected areas
of the skin thoroughly with water and soap. Allow an expert to check the charger
and the Vehicle Multilight.

Advertising