AEG HK634060XB - Manual (Page 16)

WARNING!
• Do not use the scraper or sharp objects to clean
the glass bar and the space between it and
glass ceramic. Glass bar is attached to the ce-
ramic plate.
• Do not put the pots on the glass bar.
• Make sure that the pans and pots do not touch
the glass bar.
WHAT TO DO IF…
Problem Possible cause and remedy
You cannot start the appliance
or operate it.
• Start the appliance again and set the heat setting in 10 sec-
onds.
• The child safety device or operates. Stop child safety device
or . See the section “Child safety device” or "Stop and go".
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• There is water or fat stains on the control panel. Clean the
control panel
A sound operates when the ap-
pliance is off.
You covered one or more sensor fields. Uncover the sensor fields.
Clean the control panel.
The residual heat indicator does
not come on.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone must be hot, speak to the after sales
service.
You cannot switch on the outer
rings.
Switch on the inner ring first.
A sound operates and appli-
ance starts and stops again. Af-
ter 5 seconds one more sound
operates.
You covered . Uncover the sensor field.
comes on The automatic switch off operates. Stop the appliance and start it
again.
and number come on. There is an error in the appliance.
Disconnect the appliance from the electrical supply for some
time. Disconnect the fuse from the electrical system of the house.
Connect again. If comes on again, speak to the after sales
service.
There is no signal when you
touch panel keys
The signals are off.
Switch on the signals.
16 What to do if…