AEG T76485AH - Manual (Page 16)

HINTS AND TIPS
ECOLOGICAL HINTS
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled wa-
ter, e.g. for steam ironing. If necessa-
ry clean the condensate before (e.g.
with a coffee filter) to remove possi-
ble small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes specified in the
programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the filter after each drying cy-
cle.
• Spin good the laundry before drying.
AVERAGE LAUNDRY WEIGHTS
bathrobe 1200 g
quilt cover 700 g
man’s work shirt 600 g
man’s pyjamas 500 g
sheet 500 g
tablecloth 250 g
man’s shirt 200 g
night dress 200 g
pillow case 200 g
towelling towel 200 g
blouse 100 g
ladies’ briefs 100 g
men’s underpants 100 g
napkin 100 g
tea cloth 100 g
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust
the sensor to dry with the better results.
To change the sensor conductivity:
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time the Dry Plus
and the Anticrease buttons. Hold
down until one of the symbols go
into view on the display:
–
low conductivity <300 μS/
cm
– moderate conductivity
300-600 μS/cm
– high conductivity >600
μS/cm
3. Push the Start Pause button again
and again until you set necessary
level.
4. To memorise the setting push at the
same time the Dry Plus and the An-
ticrease buttons.
WATER CONTAINER FULL —
INDICATION
By default the indication LED is always
on. It comes into the view at the end of
the cycle or when the water container is
full. When you use an external equip-
ment to drain the container, the LED
can be off.
To activate or deactivate the indication:
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time the Dry Plus
and Buzzer buttons and hold down
until you see the correct setting:
– the LED is off and the symbol
goes into the view - The
LED is permanently off
– the LED is on and the symbol
goes into the view - The
LED is activated
16