AEG T65270AC - Manual (Page 18)

TROUBLE SHOOTER AND SERVICE
TROUBLE SHOOTER
Problem
1) Possible cause Remedy
Tumble dry-
er does not
work.
Tumble dryer not connected to
mains supply.
Connect in at mains socket.
Check fuse in fuse box (domes-
tic installation).
Loading door opened. Close loading door
The Start/Pause button not
pressed.
Push the Start/Pause button.
Unsatisfac-
tory drying
results.
Incorrect programme set. Set applicable programme.
2)
The filter clogged. Clean the filter.
3)
Too high volume of the load.
Respect the maximum load vol-
ume.
Airflow slots covered up. Uncover airflow slots.
Dirt inside the drum. Clean the drum inside.
High water hardness. Set applicable water hardness
4)
.
Door does
not close
Filter not locked in position.
Put the filter in the correct posi-
tion.
Laundry locked between the
door and the seal. Put the load correctly in the
drum.
Err (Error)
on the dis-
play.
5)
Attempt to change parameters
after start of the programme. Turn the tumble dryer off and
on. Set requested parameters.
The function you set is not ap-
plicable with the set programme Turn the tumble dryer off and
on. Set requested parameters.
No drum
light
6)
Defective drum light.
Contact the service centre to re-
place the drum light.
Abnormally
elapsing
time on the
display
5)
Time to end is calculated on the
basis of: type, volume and
dampness of laundry.
Automatic procedure; this is not
a appliance fault.
Drying cycle
too short
Small laundry volume./Too dry
laundry for selected pro-
gramme.
Select time programme or high-
er drying level (e.g. Extra Dry ).
Drying cycle
too long
7)
The filter clogged. Clean the filter.
Too high volume of the load.
Respect the maximum load vol-
ume.
Laundry insufficiently spun. Spin adequately the laundry.
Very high room temperature -
no appliance fault. Lower the room temperature if
possible.
18