AEG SCS51810S0 - Manual (Page 8)

Temperature setting buttons
The temperature is adjusted using the temperature setting buttons. These buttons are con-
nected to the temperature indicator.
• Each time one of the two buttons is pressed again the temperature is adjusted by 1°C.
The set temperature will be reached within 24 hours.
Temperature indicators
The temperature indicators show several information:
• During normal operation, the temperature currently set for fridge and freezer are dis-
played.
• When the temperature is being adjusted a flashing display indicates the fridge/freezer
temperature currently set .
Temperature regulation
To operate the appliance, proceed as follows:
1. Set the required temperature by pressing the corresponding temperature regulator. The
temperature indicator will immediately show the changed setting and the temperature
indicator flashes.
2. Each time the temperature regulator is pressed the temperature is adjusted by 1 °C. The
set temperature will be reached within 24 hours.
3. The temperature indicator will change from flashing to continuous illumination.
For a correct storage of the food the following temperatures should be set:
• +5 °C in the fridge
• -18 °C in the freezer.
When the setting is changed, the compressor does not start immediately if automatic de-
frosting is currently taking place. As the storage temperature within the fridge is reached
quickly you can store food immediately after switching on.
DYNAMICAIR function
To switch on the function:
1. Press the DYNAMICAIR button.
2. The DYNAMICAIR indicator is shown.
To switch off the function:
1. Press the DYNAMICAIR button.
2. The DYNAMICAIR indicator goes off.
If the function is activated automatically the DYNAMICAIR indicator is not shown (refer to
"Daily use").
The activation of the DYNAMICAIR function increases the energy consumption.
COOLMATIC function
The COOLMATIC function is suitable for quick cooling of large quantities of goods in the
refrigerator.
To activate the function, do these steps:
8 Control panel