2 if you cannot find a solution, Installation, 1 before the installation – AEG HK614010MB User Manual

Page 9: 2 built-in hobs, 3 connection cable

Advertising
background image

Problem

Possible cause

Remedy

Residual heat indicator does
not come on.

The zone is not hot because
it operated only for a short
time.

If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.

You cannot activate the out-
er ring.

Activate the inner ring first.

There is a dark area on

the multiple zone.

It is normal that there is a
dark area on the multiple
zone.

7.2 If you cannot find a

solution...

If you cannot find a solution to the

problem yourself, contact your dealer or

an Authorised Service Centre. Give the

data from the rating plate. Give also

three digit letter code for the glass

ceramic (it is in the corner of the glass

surface) and an error message that

comes on. Make sure, you operated the

hob correctly. If not the servicing by a

service technician or dealer will not be

free of charge, also during the warranty

period. The instructions about the

Service Centre and conditions of

guarantee are in the guarantee booklet.

8. INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down

the information bellow from the rating

plate. The rating plate is on the bottom

of the hob.

Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you

assemble the hob into correct built-in

units and work surfaces that align to the

standards.

8.3 Connection cable

• For a single phase or two phase

connection use the following (or

higher) mains cable type: H05BB-F

Tmax 90°C.

• To replace the damaged mains cable

use the following (or higher) mains

cable type: H05BB-F Tmax 90°C.

Speak to your local Service Centre.

ENGLISH

9

Advertising