AEG HG694340NB - Manual (Page 16)

Problem Possible Remedy
comes on No cookware is on the
cooking zone. Put cookware on the
cooking zone.
Incorrect cookware. Use the correct cookware.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone. Use cookware with cor-
rect dimensions.
The cookware do not
cover the cross. Cover the cross fully.
and number comes
on.
There is an error in the
appliance. Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If
comes on again,
speak to the service cen-
tre.
comes on There is an error in the
appliance because a
cookware boils dry. The
overheating protection
for the cooking zones and
the Automatic Switch Off
operate. Deactivate the appliance.
Remove the hot cook-
ware. After approximately
30 seconds, activate the
cooking zone again. If the
cookware was the prob-
lem, the error message
goes out of the display,
but the residual heat indi-
cator can stay. Let the
cookware become suffi-
ciently cool and refer to
“Cookware for the induc-
tion cooking zone” to see
if your cookware is com-
patible with the appli-
ance.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit let-
ter code for the glass ceramic (it is in the
corner of the glass surface) and an error
message that comes on.
Make sure, you operated the appliance
correctly. If not the servicing by a custom-
er service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the cus-
tomer service and conditions of guaran-
tee are in the guarantee booklet.
16 www.aeg.com