AEG S53400CSW0 - Manual (Page 31)

This appliance complies with the E.E.C.
Directives.
8.4 Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
8.5 Rear spacers
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
2
4
3
1
8.6 Removing the shelf
holders
Your appliance is equipped with shelf re-
tainers that make it possible to secure
the shelves during transportation.
To remove them proceed as follows:
1. Move the shelf holders in the direc-
tion of the arrow (A).
2. Raise the shelf from the rear and
push it forward until it is freed (B).
3. Remove the retainers (C).
A
B
C
8.7 Door reversibility
WARNING!
Before carrying out any opera-
tions, remove the plug from the
power socket.
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the
doors of the appliance during
the operations.
• Remove the spacer (A) and move to
the other side of the hinge pivot (B).
• Remove the doors.
• Remove the left-hand cover pin of the
middle hinge (C,D) and move to the
other side.
• Fit the pin of the middle hinge (B) into
the left-hand hole of the lower door.
E F
A
B
D C
• Remove using a tool the cover (A). Un-
screw the lower hinge pivot (B) and
ENGLISH
31