Atmel AT89STK-06 User Manual
At89stk-06 demo board, Hardware user guide
Advertising
Table of contents
Document Outline
- Section 1
- Introduction
- 1.1 Features
- Section 2
- Hardware Description
- 2.1 Block Diagram
- 2.2 Power Supply
- 2.2.1 Power Supply Sources
- J4 - JACK PWR connector:
- J5 - 9V Battery connector:
- 2.3 RESET
- 2.3.1 Power-on RESET
- 2.3.2 RESET Push Button
- 2.4 Serial Interfaces
- 2.4.1 RS-232C
- 2.4.2 CAN
- 2.4.3 SPI
- 2.5 Board Settings
- 2.5.1 Jumpers
- 2.5.2 Solder straps
- 2.5.2.1 T89C51CC02/T89C5115 Support (SP1)
- 2.5.3 Test Points
- Section 3
- Device Programming
- 3.1 In-System Programming
- 3.1.1 Manual ISP Mode
- 3.1.1.1 Board Configuration
- 3.1.1.2 Operating Mode
- 3.1.2 Auto ISP Mode
- 3.1.2.1 Board Configuration
- Section 4
- Appendix A: Board Layout
- Appendix B: Bill of Materials
- Appendix C: Board Schematics
- Appendix D: Default Configuration
- Appendix E: References/Acronyms
- 4.1 References
- 4.2 Acronyms