Audiovox Jensen Phase Linear UMP400 - Manual (Page 5)

UCD300/UMP400
5
Antenna Connector
Power Antenna
Connect to power antenna
or amplifier. If not used, tape
bare end of wire.
Ground
Connect to ground terminal.
Memory/Battery
Connect to battery or 12 volt
power source that is always
live. The radio will not work
if this wire is not connected.
Accessory/Ignition
Connect to existing radio
wire or radio fuse.
Amplifier Wiring
Connect line out for optional
external amplifiers. The red
connector is for the right and the
white connector is for the left.
Gray
+
Blue
Black
Yellow
Red
White/Black (-)
White (+)
Gray/Black (-)
Gray (+)
Violet (+) Green (+)
Green/Black (-) Violet/Black (-)
LF/AVG RF/AVD
LR/ARG RR/ARD
Fuses
When replacing a fuse, make
sure the new fuse is the correct
type (ATO) and amperage.
Using an incorrect fuse could
damage the radio.
CD Changer
Connector
10A
WIRING
WARNING! Never combine (bridge) outputs
for use with 1 speaker.
WARNING! Never ground negative speaker
leads to chassis ground.
CAUTION: Failure to wire exactly as shown
may cause electrical damage to the radio.