AEG AR 4025 BT - Manual (Page 74)

74 ENGLISH
Installing the unit into the ISO dashboard slot
A
B
C
D
C
Detach the mounting sleeve (D) and frame (B) from ‹
the unit housing. Use the assembly keys (C) to do so.
Fit the mounting sleeve into the ISO dashboard slot. ‹
Bend the mounting sleeve tabs round with a screw- ‹
driver so that the frame is mounted securely in the
dashboard slot.
Check that the frame is secure. ‹
Connect the ISO connection of the unit to the two ISO ‹
connectors of your vehicle.
Connect the antenna cable of the vehicle antenna to ‹
the antenna adapter of the unit.
If necessary, also secure your unit against theft. ‹
Fasten the screws to the mounting bracket and to the
mounting material on the engine firewall of the car.
Slide the unit carefully into the mounting sleeve, until ‹
it clicks into place.
After all connections have been made, press the ‹ RESET
button (26) using a ballpoint pen or other pointed
object.
Attach the control panel (A), as described under ‹
„Attach control panel“.
CAUTION:
Possible damage to the cables!
When inserting the unit, pay attention to the cable ►
routing to prevent damage.
Then mount the frame. ‹
Disassemble the unit
To disassemble the unit, proceed as follows:
Remove the frame. ‹
Insert the right and left hand assembly key into the ‹
respective slots on the sides of the unit. (The tabs are
now bent back.)
Pull out the unit. ‹
NOTE:
If the housing is uneven, the tabs on the mounting ►
sleeve may become jammed. Use the assembly keys
to release the tabs.
Installation for Toyota or Nissan
NOTE:
Mounting sleeve, frame and mounting strip are not ►
required.
Use the threaded mounting holes on the sides of the unit
(A), to fasten the unit to the mounting brackets (supplied
with your vehicle). The holes are labeled T (for Toyota) or
N (for Nissan).
A
B
C
D
B
Loosen the mounting screws for the left and right ‹
hand catches on the front of the unit and remove the
catches.