AEG HK855200IB - Manual (Page 27)

4. DAILY USE
WARNING!
Refer to the Safety chapters.
4.1 Activation and
deactivation
Touch for 1 second to activate or de-
activate the appliance.
4.2 Automatic Switch Off
The function deactivates the appliance
automatically if:
• All cooking zones are deactivated (
).
• You do not set the heat setting after
you activate the appliance.
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before
you use the appliance again, wait for
the cooking zone to cool down.
• You use incorrect cookware. The sym-
bol comes on and the cooking
zone deactivates automatically after 2
minutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
comes on and the appliance
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off
function:
•
, - — 6 hours
• - — 5 hours
• - — 4 hours
•
- — 1.5 hours
4.3 The heat setting
Touch the control bar at the heat set-
ting. Move your finger along the control
bar to change the setting. Do not re-
lease before you have a correct heat set-
ting. The display shows the heat setting.
4.4 Cooking zone indication
min.
The horizontal line shows the size of the
cooking zone and the minimum cook-
ware diameter. For more information re-
fer to “Technical Information” chapter.
4.5 Bridge function
The Bridge function connects two cook-
ing zones and they operate as one.
First set the heat setting for one of the
cooking zones.
To activate the Bridge function touch
. To set or change the heat setting touch
one of the control sensors.
To deactivate the Bridge function touch
. The cooking zones operate inde-
pendently.
When you use only one cooking zone of
the pair we recommend that you use the
rear cooking zone. Also when you use
large cookware we recommend that you
put it near to the rear cooking zone.
4.6 Automatic Heat Up
You can get a necessary heat setting in a
shorter time if you activate the Automat-
ic Heat Up function. This function sets
the highest heat setting for some time
(see the diagram), and then decreases to
the necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
ENGLISH
27