AEG F55602VI0P - Manual (Page 27)

7.1 Using the detergent
20
30
M AX
1 2 3
4
+ -
A B
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
7.2 Setting and starting a
programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the
appliance. The appliance is in setting
mode when the display shows 2 horizon-
tal status bars. If the control panel does
not show this condition, press RESET.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Press one of the programme buttons
again and again until the display
shows the number of the programme
you want to start.
• The programme number flashes in
the display.
• If you want you can set the applica-
ble options.
4. Close the appliance door, the pro-
gramme starts. The programme du-
ration starts to decrease with steps of
1 minute.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
• The Delay indicator comes on.
3. Close the appliance door. The count-
down starts.
• When the countdown is comple-
ted, the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Cancelling the delay start
while the countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press RESET. The display shows 2
horizontal status bars.
2. Set the programme again.
Cancelling the programme
1. Press RESET. The display shows 2
horizontal status bars.
Make sure that there is detergent
in the detergent dispenser be-
fore you start a new programme.
ENGLISH
27