AEG F54030VI0 - Manual (Page 30)

Manual adjustment
Turn the water hardness dial to the po-
sition 1 or 2.
Electronic adjustment
1. Press the on/off button to activate
the appliance.
2. Make sure that the appliance is in
setting mode. Refer to ‘SETTING
AND STARTING A PROGRAMME’.
3. Press and hold function buttons (B)
and (C) at the same time until the in-
dicators of function buttons (A), (B)
and (C) flash.
4. Press function button (A).
• The indicators of function buttons
(B) and (C) go off.
• The indicator of function button
(A) continues to flash.
• The acoustic signals operate. Ex-
ample: five intermittent acoustic
signals = level 5.
• The display shows the setting of
the water softener. Example:
= level 5.
5. Press function button (A) again and
again to change the setting.
6. Deactivate the appliance to confirm.
FILLING THE SALT CONTAINER
CAUTION!
Only use dishwasher salt. Other
products can cause damage to
the appliance.
Water and salt can come out
from the salt container when
you fill it. Risk of corrosion. To
prevent it, after you fill the salt
container, start a programme.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt con-
tainer (only for the first time).
3. Fill the salt container with dish-
washer salt.
4. Remove the salt around the open-
ing of the salt container.
5. Turn the cap clockwise to close the
salt container.
30