AEG HC652600EB - Manual (Page 13)

• Use a special scraper for the glass.
6.2 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, and food with sugar. If not,
the dirt can cause damage to the hob.
Put the special scraper on the glass
surface at an acute angle and move
the blade on the surface.
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat
stains, shiny metallic discoloration.
Clean the hob with a moist cloth and
some detergent. After cleaning, rub
the hob dry with a soft cloth.
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem Possible cause Remedy
You cannot activate or oper-
ate the hob. The fuse is released. Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
You touched 2 or more sen-
sor fields at the same time. Touch only one sensor field.
STOP+GO function oper-
ates. Refer to "Daily use" chapter.
There is water or fat stains
on the control panel. Clean the control panel.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated. You put something on one
or more sensor fields. Remove the object from the
sensor fields.
Residual heat indicator does
not come on. The zone is not hot because
it operated only for a short
time. If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Automatic Heat Up function
does not operate. The zone is hot. Let the zone become suffi-
ciently cool.
The highest heat setting is
set. The highest heat setting has
the same power as the func-
tion.
The heat setting changes
between two levels. Power management function
operates. Refer to "Daily use" chapter.
ENGLISH 13